Well Water Rainwater Harvesters
The R1/R2 Well Water Systems
The Well Water range of light industrial, commercial and domestic harvesting systems treats the rainwater from your roof area (up to 150m²) through a Micron Filter to DIN Standards. No particle larger than 0.28mm will enter the Well Water System. Over 90% of the rainwater is filtered and collected by the system.
The Well Water system has an integral overflow system fitted with a non return valve to prevent surging from the main drains, along with a water trap to stop smells and odour from overflow drains tainting the rainwater in the Water Well System.
The patented filter system can be installed either above or below ground as with all Well Water components the filter carries a guarantee.
In addition to the high performance Jung submersible pump the Well Water system incorporates the Easy Press controller. This will operate the pump immediately when the valve or tap in the pipe system is opened and stops the Jung Pump immediately when the valve or tap is closed, or if the pump runs dry. The controller can operate up to 15m away from the Jung Pump.
No programming is required for the Easy Press controller. The R1 is designed for above or below ground installation. The storage vessels for the Well Water Systems are manufactured from either HDPE (high density polyethylene) or Resin Transfer Moulded Glass & Resin.
The R2 Well Water System is designed to supply internal appliances as well as the outdoor uses. Rainwater can be used for toilet flushing and washing machines.
The R2 system incorporates vortex filters solenoids and pump control units as well as the many design features mentioned above for the R1 Well Water System. The R2 can harvest rainwater from larger roof areas greater than 150m². The R2 system is designed for below ground installation.
For further information, please visit the Well Water Website or use our Enquiry form below.